Status bar when in Edit Mode

rbuser

I have 11.01 installed (have not installed 11.03 yet).

I was just curious if there is a way to do the following. When in edit
mode for a report, the status bar first column has the name of the
component currently selected. However sometimes the name is too large
to fit in the first column and I need to unmaximize the dialog (it
defaults to maximized) and then maximize it again in order to increase
the size of the first column. Usually this works, sometimes it does
not. But, is there a way to have the first column be the column that is
stretched to fit the width instead of the last column that appears to be
stretched when first displaying the edit dialog?

nicocizik

Hi Jeff,

Try installing RB 11.03 and see if the behavior is different. In my
testing, the left column in the status bar is always the largest and the
right columns (Left, Right, Width, Height) are fixed on the right side of
the designer.

--
Regards,

Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com