Just install RB11.04 on Delphi2006 on XP. Wrote simple report. Preview work fine. When I compile it, receives [Pascal Fatal Error]F2039 Could not create output file 'C:\xxxxx' Build gives same result.
For future reference, please use your real name when posting to these newsgroups.
The error usually indicates that the "xxxxx.dcu" file mentioned in the error is read only. Check the file(s) shown and be sure Delphi is able to make updates.
Comments
For future reference, please use your real name when posting to these
newsgroups.
The error usually indicates that the "xxxxx.dcu" file mentioned in the error
is read only. Check the file(s) shown and be sure Delphi is able to make
updates.
--
Regards,
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com
Further Information,
The filename before was my executable.
Now getting.
Access violation at address 20C204BD in module 'coreide100.bpl'. Read
address 00000024.
Followed by.
List index out of bounds(81).
Mike Mucha
By "using your real name" I meant in the "From" field when you post (instead
of your email address).
You may have a corrupt installation. Please follow the steps in the article
below on cleaning a corrupt installation.
http://www.digital-metaphors.com/rbWiki/General/Installation/Cleaning_Up_a_Corrupt_Install
--
Regards,
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com