Gap between detail bands
I use the OnPrint event from a TppShape to create a gray bar. This works,
but I now have a report that requires every three lines to be a gray bar
which also works.
The problem is that a very small but noticeable gap of white appears between
the gray bar bands. How can I remove this small gap.
TIA
Tom
but I now have a report that requires every three lines to be a gray bar
which also works.
The problem is that a very small but noticeable gap of white appears between
the gray bar bands. How can I remove this small gap.
TIA
Tom
This discussion has been closed.
Comments
set its border to match the fill (or its Pen to match the Brush, you
follow?) or else there'll be a thin white line where the border is (or is
not ;-)).
Robert Leahey
robert@leahey.com