jumping from a subreport to preview and back
Hi,
I've quite a big report with 10 subreports.
When I'm busy with designing subreport 10 (for instance) and I do a preview
to check my design it works fine. But when I close the previewer, RB goes
back to the main report and not to subreport 10 (where I was working).
I have to lookup subreport 10 everytime and that not a nice job when you
have to do that a lot of times with complex reports.
Can RB go back to the subreport I was working in after closing the
previewer?
This also happens with RAP forms.
I work with RB 7.3
Rob
I've quite a big report with 10 subreports.
When I'm busy with designing subreport 10 (for instance) and I do a preview
to check my design it works fine. But when I close the previewer, RB goes
back to the main report and not to subreport 10 (where I was working).
I have to lookup subreport 10 everytime and that not a nice job when you
have to do that a lot of times with complex reports.
Can RB go back to the subreport I was working in after closing the
previewer?
This also happens with RAP forms.
I work with RB 7.3
Rob
This discussion has been closed.
Comments
I'm not sure when this was changed but in my testing with RB 9.01, you are
able to click the Preview tab, then back to the Design tab and still remain
designing the subreport you were using. Try downloading a trial version of
RB 9.01 and see if it has been changed for your needs.
--
Regards,
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com