Reports becoming unwired
Everytime I open a my application in Design mode, I am presented with
Class HistogramSeries not found. Ignore the error .... you know the rest.
If I say ignore, I get the same message for TColorline so it is not just a
TdbChart phenomenom.
If I then allow the project to open and go into the Report, I find all my
images unlinked, also.
My recoarse has been to use the history feature of Delphi2006 and roll back
to a previous DFM. It seems to not be able to stream the properties! Can
you tell me what is causing this and how to correct it?
Thanks
Class HistogramSeries not found. Ignore the error .... you know the rest.
If I say ignore, I get the same message for TColorline so it is not just a
TdbChart phenomenom.
If I then allow the project to open and go into the Report, I find all my
images unlinked, also.
My recoarse has been to use the history feature of Delphi2006 and roll back
to a previous DFM. It seems to not be able to stream the properties! Can
you tell me what is causing this and how to correct it?
Thanks
This discussion has been closed.
Comments
When a form is loaded at designtime, all the components that were present
inside the report are automatically created and given their saved property
values. If a component is not installed into the IDE, you will receive the
error below. Are you certain you have the save or equivalent version of
TeeChart properly installed into the Delphi IDE as you did when the
application was created?
I believe the TColorLine is a TeeChart component as well so the problem is
most likely related to above.
The image linking issue is not a known one. Which version of ReportBulder
are you using?
--
Regards,
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com