floating point error when showing a report

rbuser

I have a report that sometimes will cause a floating point error. I have
gone over the data and the data all looks good. Sometime I have noticed the
last few times this has happened is you can go back tomorrow and the report
will work just fine then all of a sudden some point later the error will
happen and continue to happen over and over then it disappears again seems
like it is always the next day. I am using 10.7 and D2007

I have seen lots of problems about something similar and they all seem to
say you should upgrade to the latest. I think I am using the latest. Any
ideas?

Thanks in advance,
Rodger

nicocizik

Hi Rodger,

Try to isolate the problem. Try to get the error again with your library
path pointing toward \RBuilder\Source\ and see where in the RB source the
error is occuring. Are there reports that work all the time? How is the
report different that gets the error from these reports?

--
Regards,

Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com