Home› Devices
ReportBuilder 22.06 now available including Delphi 12.2 support!
New Blog Posts: Merging Reports - Part 1 and Part 2

Problems with printer HP laserjet 3800 DTN

rbuserrbuser
edited September 2008 in Devices
Hello,

Some times (not always) the printer Laserjet 3800 has as device screen
instead of laserjet 3800.
When I restart the program then the printer is correct again, but after some
time it will turn on screen again.
Anny suggestions?

I run the latest reportbuilder version.

Comments

  • nicociziknicocizik
    edited September 2008
    Hi Rob,

    How is the LaserJet connected to your computer? If it is perhaps a network
    printer, it could be possible that your machine has not yet found or
    initialized the printer over the network before you are running your
    application.

    --
    Regards,

    Nico Cizik
    Digital Metaphors
    http://www.digital-metaphors.com

    Best Regards,

    Nico Cizik
    Digital Metaphors
    http://www.digital-metaphors.com
  • rbuserrbuser
    edited September 2008
    Heloo Nico,

    The printer is connected to the network,
    it occurs when the user has printed before
    so the printer is known when starting the program.

    Best regards,
    Rob Nowee

  • nicociziknicocizik
    edited September 2008
    Hi Rob,

    In this case, the issue is most likely due to a loss of resources or a
    memory leak. Try running your application through a memory manager such as
    AQTime or FastMM and see if you can find where the problem is occuring.

    --
    Regards,

    Nico Cizik
    Digital Metaphors
    http://www.digital-metaphors.com

    Best Regards,

    Nico Cizik
    Digital Metaphors
    http://www.digital-metaphors.com
This discussion has been closed.