Pipeline selection dialog - please make it larger!

rbuser

Hi,

Whenever I attach a new report to a pipeline via Report | Data, it
shows a tiny dialog... Please make this dialog larger or resizable and
keep size/pos...


Thanks!

With regards,

Martijn Tonies
(who has finally been able to get things going)

nicocizik

Hi Martijn,

It is possible to replace any form in ReportBuilder except for the
ReportDesigner. You can replace the ppDatDlg form located in the
RBuilder\Source\... directory if you would like to change the way the Data
Dialog works.

------------------------------------------------------------
Tech Tip: Replacing Built-in Dialogs/Forms in ReportBuilder
------------------------------------------------------------

ReportBuilder has an open architecture for replacing any of the built-in
dialogs. You can replace any of the built-in dialogs by creating a new form
that inherits from an abstract ancestor and then registering it as the new
built-in dialog.

For example to replace ReportBuilder's preview dialog you could

1. Create a new Preview dialog by renaming ReportBuilder's default preview
dialog, then doing a SaveAs to save it under another unit name.

The default dialog resides in RBuilder\Source\ppPrvDlg.pas and the form is
called ppPreviewDialog. You should assign your form a unique name, for
example, myPreviewDlg, and save the unit to another name. Also save the unit
to the directory where your other forms are stored (not RBuilder\Source).

2. Make desired changes.

You will notice that the preview dialog inherits from an ancestor
TppCustomPreviewDialog - this ancestor resides in ppForms.pas (where all the
abstract ancestor forms for ReportBuilder are defined).

3. Register the new form.

Declare an initializtion section at the bottom of the unit:

initialization

ppRegisterForm(TppCustomPreviewer, TmyPreviewDlg);


4. Add the new unit to your project and compile.

Now your preview dialog should be automatically created and destroyed by
ReportBuilder. The two page preview dialog in the
RBuilder\Demos\Reports\Demo.dpro was created this same way. The only
difference is the ppRegisterForm call is in then OnClick event of the
button.

--