Pb with Group
Hello
I would like to print some lines with a count after information (subreport1
in a region). When this information is equal to 10, I don't add blank line
otherwise I must display a complement until to have 10 lines.
My result of the query give for example 4 results in my subreport (4 lines).
Afetr I would like to indicate 6 blank lines (to arrives to 10) with a count
on each line. I realize some groups with a RAP on beforeGroupBreak to
active the region to visible or not.
There is two pass and In the first pass my information are displaying (4
lines) and 9 blanks lines also (because when I have only one information I
must display 9 blank lines). This result are in two pages. And in the second
pass ReportBuilder recalculate and display the correct number of line (6)
but I have a blank page (due to the first calc). This second blank page is a
problem. I would like only one page!
Could you help me. Thanks
--
R?gine LEBRETON
JOUVE S.I.
Immeuble Hercule II
12, rue des Landelles
35510 Cesson-Sevigne
FRANCE
Tel: +33 (0)2 99 86 98 16
Fax: +33 (0)2 99 86 98 01
eMail: rlebreton@rennes.jouve.fr
The present email and all information included therein do not constitute a
legal agreement accorded by Jouve.
All legal agreements must be formulated in writing on paper by a legal
representative of JOUVE.
If you have received this email by mistake, please inform us of that fact
and destroy the email and any documents it might contain. Thank you for your
cooperation.
I would like to print some lines with a count after information (subreport1
in a region). When this information is equal to 10, I don't add blank line
otherwise I must display a complement until to have 10 lines.
My result of the query give for example 4 results in my subreport (4 lines).
Afetr I would like to indicate 6 blank lines (to arrives to 10) with a count
on each line. I realize some groups with a RAP on beforeGroupBreak to
active the region to visible or not.
There is two pass and In the first pass my information are displaying (4
lines) and 9 blanks lines also (because when I have only one information I
must display 9 blank lines). This result are in two pages. And in the second
pass ReportBuilder recalculate and display the correct number of line (6)
but I have a blank page (due to the first calc). This second blank page is a
problem. I would like only one page!
Could you help me. Thanks
--
R?gine LEBRETON
JOUVE S.I.
Immeuble Hercule II
12, rue des Landelles
35510 Cesson-Sevigne
FRANCE
Tel: +33 (0)2 99 86 98 16
Fax: +33 (0)2 99 86 98 01
eMail: rlebreton@rennes.jouve.fr
The present email and all information included therein do not constitute a
legal agreement accorded by Jouve.
All legal agreements must be formulated in writing on paper by a legal
representative of JOUVE.
If you have received this email by mistake, please inform us of that fact
and destroy the email and any documents it might contain. Thank you for your
cooperation.
This discussion has been closed.
Comments
You should not use the first pass to make any calculations or alter the
report if you plan to do so if the second pass as well. This will usually
cause problems in the generation process. You will also not be able to find
out the detail line count in the first pass. As an alternative, I would
suggest trying a fixed subreport rather than toggling the visibility of a
group.
--
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com