Hi, is it possible to switch off the dotted line of the fields in the designer?... make it a solid line again? It's much easier to find the right position if it's a solid line than a dotted line.. (1280x1024)
Unfortunately this was a concious decision our team made to enhance the look of the designer. If you would like to customize the way the design controls look at run time, take a look inside the ppDesignControls.pas file. Specifically at the TppDesignControl.PaintFrame method if you would like to change the outside border of each control in the designer.
Comments
Unfortunately this was a concious decision our team made to enhance the look
of the designer. If you would like to customize the way the design controls
look at run time, take a look inside the ppDesignControls.pas file.
Specifically at the TppDesignControl.PaintFrame method if you would like to
change the outside border of each control in the designer.
--
Regards,
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com