Master-Detail DBPipeline
Master dataset
SELECT * FROM EMPLOYEE
Detail dataset
SELECT * FROM EMPLOYEE_DETAILS
How to set up the masterdatasource and masterfieldlink ?
I cannot setup the MasterDataPineline property of the detail datapipeline
because although I can see a list of datapipeline in the dropdownbox but I
could not choose that.
SELECT * FROM EMPLOYEE
Detail dataset
SELECT * FROM EMPLOYEE_DETAILS
How to set up the masterdatasource and masterfieldlink ?
I cannot setup the MasterDataPineline property of the detail datapipeline
because although I can see a list of datapipeline in the dropdownbox but I
could not choose that.
This discussion has been closed.
Comments
I am a bit unclear about what the problem is. Why are you unable to choose
the correct datapipeline as the master datapipeline? Note that when using
datapipeline linking you will need to order your detail dataset on the
linking field. See the article below for more information.
------------------------------------------------
TECH TIP: Fundamentals of Report Data Traversal
------------------------------------------------
1. Single Table Listing Report
Assign the Report.DataPipeline property and leave the
DetailBand.Pipeline unassigned.
The report will traverse the data from start to end (based on the
datapipeline range settings and honoring any filters you've placed on
the datset etc.)
2. Master/Detail Report:
A. Assign the Report.DataPipeline property to the master. Create a
subreport in the detail band and assign the childreport.DataPipeline to
the detail datapipeline.
Use either the visual linking features available from the Report
Designer's Data tab, or Use standard Delphi dataset linking to define
the relationships between the datasets.
The Report will traverse the master records and for each, the subreport
will traverse the detail data related to the master.
3. Master with 2 Details
Configure as in 2 above. Add an additional subreport to the detailband.
Set subreport.ShiftRelativeTo property to the point to the first
subreport. Connect the ChildReport's DataPipeline to the detail data.
4. Report connected to no datapipelines.
When Report.AutoStop is set to True, the Report will print a single
detail band.
When Report.AutoStop is set to False, the Report will print detail bands
until instructed
to stop. You can control when the report stops by setting the
Report.PageLimit property or by calling Report.DataTraversalCompleted
method. Otherwise the report will never stop.
Additional Notes:
----------------
1. SubReports have a Report property that is of type TppChildReport.
Thus, programmatically you can code SubReport.Report.DataPipeline :=
myDataPipeline.
2. ChildReport's traverse data following the same rules as above. A
ChildReport prints in its entirety each time it gets a turn to print.
3. For a Child style SubReport use the Title/Summary band rather than
the Header/Footer (or use a GroupHeader/GroupFooter combo). A standard
Header/Footer will not work because these always print at the very
top/bottom of the page.
4. Do not filter the dataset of modify it any way once the report.Print
command is issued. If you need to do master/detail and cannot use
linked datasets, then use the master DataPipeline.OnRecordPositionChange
event to filter the detail dataset.
5. The reports and datapipelines use dataset bookmarking. Make sure
the dataset can support bi-directional navigation.
Check out the RBuilder\Demos\Reports\Demo.dpr project. Reports 0071,
0072, 0073 show examples of master w/mutliple detail style reports.
Number 0072 has two detail reports.
--
Regards,
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com
Nico Cizik
Digital Metaphors
http://www.digital-metaphors.com