Home General
New Blog Posts: Merging Reports - Part 1 and Part 2

Switching between preview and design tab

edited September 2001 in General
hi,
why does it take so long to switch between the preview tab and the design
tab
sometimes it takes up to 1 minute before the design tab is usable again
the report isn't that heavy (1 master and 4 subreports each one has its own
datapipe)
TIA
marc

Comments

  • edited September 2001
    Can you check to see if your datasets are being closed and reopened in this
    process? If you have RAP, it will cause a an additional delay when moving
    back to the design workspace from the previewer. The reason is that the
    report definition is streamed down and streamed back up when RAP is
    invovled.


    Cheers,

    Jim Bennett
    Digital Metaphors


  • edited September 2001
    ah, thats why i see a temp TppReport appearing on the form...
    cu
    marc

This discussion has been closed.