Home Subreports
New Blog Posts: Merging Reports - Part 1 and Part 2

Page style

edited May 2004 in Subreports
Hello

In my template, I have a header, a page style and detail with subreports.
The content of the page style is used to display a special header from the
second page. But when I have a lot of instructions in the subreport, the
data begin on the first page (correct) but the rest of these instructions
upon the header in the second page.
Could you help me to place the rest of these instructions below the header
of page style?

Thanks

--

R?gine LEBRETON

JOUVE S.I.
Immeuble Hercule II
12, rue des Landelles
35510 Cesson-Sevigne
FRANCE

Tel: +33 (0)2 99 86 93 67
Fax: +33 (0)2 99 86 98 01
eMail: rlebreton@rennes.jouve.fr

The present email and all information included therein do not constitute a
legal agreement accorded by Jouve.
All legal agreements must be formulated in writing on paper by a legal
representative of JOUVE.
If you have received this email by mistake, please inform us of that fact
and destroy the email and any documents it might contain. Thank you for your
cooperation.

Comments

  • edited May 2004

    Try using the Subreport OverFlowOffset property. The following is from the
    online help topic for OverFlowOffset...


    Description

    Use the OverFlowOffset property to define the vertical space that should be
    above the component when it is overflowing onto an additional page. The
    OverFlowOffset is expressed in report units.

    Notes

    The OverFlowOffset acts as a margin between the stretching component and the
    top of the page.


    --
    Nard Moseley
    Digital Metaphors Corporation
    www.digital-metaphors.com


    Best regards,

    Nard Moseley
    Digital Metaphors
    www.digital-metaphors.com
  • edited July 2004
    Hi, you could try to use the properti TOP of the subreport.
    When the report goes to another pagem the TOP property saids wich is the
    Top Heigh from where start transversing data , you can use this property to
    your first subreport ans then use the property of Shiftrelated to, on the
    nexts ones.



This discussion has been closed.